Posted by Miguel (4.40.20.153) on September 18, 2000 at 10:19:00:
In Reply to: some notes posted by pinksharkmark on September 18, 2000 at 03:56:38:
The word "extraction" reminded me of the lab..lol
Anyway, unless psy is solvent-sensitive, I would
use an organic solvent to extract it, i.e.:
ethanol, or ether. Subsequently, I would allow the
solvent to evaporate at room temp. This shoould not take
but a couple of minutes with ether (make sure that
you don't light up that cig if you are using ether,
CH would be your least concern then, roflmao!!!).
Rinse the container where psy was extracted with
water or some other aqueous-based, potable solution.
Drink that solution. I imagine that the taste
will not be nearly as bad as that of the tea. Also
extraction may result in a higher dose and purity.
Moreover, there will not be any heat damage to the
psy molecule.
Miguel